You may or may not have seen the documentation of my omnibot build (B.o.b. - Bret's Omnibot), but here he is completed. Bob's Mods: Camera, head turning, right shoulder articulated, left shoulder, elbow, wrist, and claw articulated, sonar, lighting, EL wire accents. I am just working on him here with my joystick gamepad, playing with different functions. But Bob is ready to go - and thanks for the salt little guy.
without further adieu - Bob:
By bret.tallent
— Last update
Other robots from Synthiam community
Cem's Eyepod Using Neopixel & Ardiuno Nano, Conrtolled Via A...
Before my 3D printer went down I managed to print out ( a while ago ) one of Perrys designed eyepods assembles. While Im...
Troy's Meet Pinhead!
Its just a concept right now but I wanted others to see that the scale doesnt quite match. Right now its just stacked on...
DJ's Hasbro R2d2 Hacked With Iotiny
This build was in two parts. The original build was hacked live at Comic Expo in Calgary Alberta with an EZ-B v3 in...
Very nice job bret!!!!!! Lookin' good!!!!!!! you ended up doing some of the same things I did on myOmni. EZ-B in the cassette draw. I was thinking about a black paint job trimmedwith gold. I ended up with silver overall with gold trim. I went through your build pics but didn't see one on how you mounted the head servo. Do you have any pics of the set up? I had got everything done accept for his head set up. That bot got put on hold for a bit when I went on to other projects. I wanted to use my EZ-B in another project. I will eventually finish him. Again nice build! Oh, I did some similar LED's in his front plate too. Rock on!!!!! Lloyd
@Lloyd - Thanks! Sorry, I did not get any pics of the head servo. But what I did was to mount a piece of angle plastic across the bot (using hot glue) and cut a hole in it so the servo would just slip down into it. Then I secured the servo horn to to a flat piece of aluminum and mounted that to the head. I hope that is clear. If not, I can make up some drawings.
Very nice!
I think I follow what you did. However, like the old saying goes.................a picture is worth a thousand words.Once I get the head servo in I can swap in one of my EZ-B's and bring him to life. Thanks. Lloyd
@DJ Sures Hello!
@Robotz012248 Hello!
So do you have a omnibot.project omnifreak?
By the way, what did you do with the flashing LED's? Did you use EZ-B digital pins or did you create a circuit to flash them?