Robot Building Questions

Sound Activated Circuit - Pc Vs. Ezb

I followed the tutorial to make the LED flash when my robot speaks. I noticed that if I have it set to the PC Speaker, the LED flashes in sync with the speaking but if I switch to the EzB, the flashing is not in sync and ends way before the talking completes. I am using the code from the tutorial (see below). # Sound Servo to PWM range Script #...

Connection Chime

Heya guys. Anyone know if its possible to disable, remove, or replace the "i have successfully connected to your network" chime from the connection startup?

Can't Configure Rovi As A Wifi Ap

We are trying to reconfigure the Rovi to be a Wifi AP. We can connect to the Rovi via my router, we can access the Rovi's configure pages, both from my PC and my tablette, we can apparently save the "EZ-B Wi-Fi Access Point Mode Configuration", we then reboot the Rovi, either using its power switch or the reboot option from its Diagnostic...

2S Lipo Vs Servo

First I like to say that i'm very happy with your products But here we go A fully charged lipo puts out 8.2 volts and the servo's that are in the kits can have max 7.4 volts. I used in my projects cheap towerpro 995 servo's and a stepdown regulator to put out max 6 volts because if i put the full lipo voltage on them they begin to smell funny and...

Camera Grid Lines

I find when using the Camera, the grid lines change or fail to stay as set. I try to save the set locations of the lines, but when I reload the project I have to reset the grids again. Thanks, Ron