I am using ARC software with 2 iotinys controller, 2 EzB4 controllers - 3 EZ-ROBOT 1300 lithium batteries for the four Ez 360 HDD servos for the two arms, two 996R servos for the grippers, 2 DFRobot rotation hex bases for head movement and body movements. with 2 EZ-robot servos HDD, 2 RGB for the eyes - EZ-Robot HDD servo and moving camera - still need a mouth
from servo City: 4 gearboxes , channels, parts, extensions, Prowler Robot Kit (wheels, 4 motors, h-bridge pwm motor controller
Here is a sample video
EzAng
By EzAng
— Last update
Discover more robots
Luis's Using The Sure Dc Ss503v100 With Ezb4 From Ez-Robots
Connect Sure DC SS503V100 compass to EZ-Robots EZB4 via UART: RX/TX wiring, set OPT high to 3.3V, 4ft wire tested,...
Smarty's Ez-Robot Halloween Witch Esmeralda
Esmeralda the Witch prop: 180 cm tall, 6.6 kg, PIR sensors, camera, light & sound sensors, loud onboard sound system...
Faengelm's Rider The Ball Kicker Servo Port Numbers
Set Synthiam ARC project port numbers to run Auto Position Actions like Kick, Thanks, and Frank for proper action...
ezang
here's another piece of the puzzle .
it goes here . same on the back side . there are two .screw M3
it looks like this then .
Looks great, how long did it take to print?
I am at the grandkids home, can't do much from here, but I will check in now and then
EzAng
ezang
i think 3 pieces is about 11 houres on my printer.maybe your printer is faster.
Look good, I don't know how fast I can print
when I get back, I need to print again the pinky for the hand, broke putting the screws into it it :-(
ezang
print the normal speed that is original in your slicer . howmuch infil do you use ? i use some 20 to 30 infill.
I use 20 or same as you
I have been printing the rotation wrist now for my "Thing" hand from the Addams family
Just need more time, :-)
EzAng
My last piece for the wrist I upped the speed to 80 and up the nozzle heat
Turning into a printing fool , lol