This is the most updated model of the LEVi Platform
By jstarne1
— Last update
Discover more robots
PJ's Ez-Truck
Convert an R/C truck to EZ-Robot using EZ-B v4, IoTiny, L298N H-bridge, HC-SR04 sensors, servos, camera and scripted...
Bumsteadsean's Synthiam Spray Steam Mop
Convert a Shark Steam Spray Mop into an EZ-Robot Steam Spray Mop-DIY robotics upgrade inspired by Team DJ
Lars1989's Omnibot 2020 - The Next Generation
Revive Omnibot 2000 with an ez-robot kit and L298N motor controller; add small servos for arms and test a 6V 5Ah gel...
Thank you for the comments Alan. I do plan on having accessories that can be mounting by drilling holes through the body. I think I will make some kind of template for each accessory that can be printed and used as a install guide for each add on.
Full body, smoothed edges, doors and drawers in place and buttons for releasing the top door and battery drawer.
Full Body frame with drawer and top hatch removed, no batteries or electronics rack here.
Top Door to the Body
Rear drawer and battery holder
Din mount for electronics, each board or motor driver will have its own blade mount for the DIN 3d printed.
Cool. You could meet the EZ-Bit need by having a template for the EZ-Bit mounting plate
a couple coats of primer and a few coats of rubberizing spray