This is the most updated model of the LEVi Platform
By jstarne1
— Last update
Other robots from Synthiam community
Ezang's My Tightrope Robot Without The Squeak, Sorry For The...
My video without the squeak 0 My tight Rope robot, enjoy
Halbinath's Traxbot - My First Robot
I picked up a EZ robot kit a while back and it sat on the shelf for a while. I finally got the inspiration I needed to...
Brw's New Robot And A Bluetooth Question
Good evening. Well i been printing myself off a new robot based on six. Its going awesome far as i can tell. but im...
Thank you for the comments Alan. I do plan on having accessories that can be mounting by drilling holes through the body. I think I will make some kind of template for each accessory that can be printed and used as a install guide for each add on.
Full body, smoothed edges, doors and drawers in place and buttons for releasing the top door and battery drawer.
Full Body frame with drawer and top hatch removed, no batteries or electronics rack here.
Top Door to the Body
Rear drawer and battery holder
Din mount for electronics, each board or motor driver will have its own blade mount for the DIN 3d printed.
Cool. You could meet the EZ-Bit need by having a template for the EZ-Bit mounting plate
a couple coats of primer and a few coats of rubberizing spray