Playing around learning the software . Camera and arm are next !
J.W.
By ww321q
— Last update
Discover more robots
Rb550f's Brookstone Ezb Teleprescence Robot
Broostone Rover 2.0 telepresence robot with 7" Android tablet, teflon anti-tip sliders, servo-based stabilization...
Ezang's Mr. Conehead Dancing, Take 1 - I Will Try More...
Stabilize hard-to-balance Mr. ConeHead for dancing, preparing for Take 2.
Leversofpower's Un2003a 28Byj48 Stepper Motor Project
Implement the UN2003A 28BYJ48 stepper controller for low-cost open-loop positioning; easy hardware setup; listed in...
It was the bucket for the backhoe. I split it in half then cutout the side and used that piece to reinforce the other side
i see that ,good idea looks good just got my board in,and made a order for 2 more
ww321q you have some genius hacking ideas! You're inspiring me to be more creative.
@skater_j10 it's about time you built a robot
one of the most helpful guys here and still haven't finished anything yet!
@ww321q i agree with skater, you're a smart cookie
I've already changed the claw. I'm not using those aluminum brackets I made. I went to 3 small gear ssalvaged from the toys gearbox.I want to cram 2 small servos between the claws to keep it short. Once I get that done the rest if the arm should go right together.
J.W.
Been busy for a week and out of town . Finally got to do a little more on testbot
Cool!
Very nice, keep up the great work testbot is turning out great, alot of ideas for others to build on and incoroperate into their own.