cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Other robots from Synthiam community
J's Rover My First Bot
this is my first robot i mainly wanted it to just drive around the house as a scout then one of my modified servos went...
Rb550f's Genus: Crabius Roboticus
Here is another creation part Attacknid and part Robosapien. His name is HERMY. Controlled via EZB v3.I use the...
DJ's Spider Robot
This robot uses two DC motors instead of modified servos. The ADC Distance Sensor detects objects and the autonomous...
i see you put grooves in your omnibot wheels for a track idea JOSH i have a full set of wheels you can buy
Thanks but the wheels I have are fine. Great news! Jarvis base got here , bad news is ups was not gentle and split one corner and chipped off a piece about a inch long. I can fix it though. Thanks to Sam. Mad props!
I will fill that chip in and fiberglass the corners from the inside just like the arms for overall strength. My favorite part is the from has the same curve as the stock piece and this eliminates the gap that was there originally for a little rubber bumper.
THat is awesome! Sam did it up nice for you.
Hi Josh, keep that bumper if you still have it - I might need it for spares
Mike
thats bad news ,but at least it can be fixed
on the plans for the 2 servo's you just have wait until my design gets done then will add them om its surprise just have to wait for it
Damn UPS. I even put extra cardboard in there for support. I am glad it wasn't too bad.
Yeah the forming it to fit is all about the heat gun.
Ok so I got to epoxy.some cracks no biggie , t took me a hour to clear away the dynamat from the inside edge of.the base all the way around. Then I hit the inside with 80 grit sand paper to prep for fiberglass adhesion.
Each corner will get 2 layers of glass , the rest of the base will get a single layer.
Ok I tacked the matt in place with ca glue with several dots , I'm waiting about 30 minutes to make sure its all secure. I went ahead and did 2 layers of matt all the way around. I didn't initially realize it but 4 inches of walls all the way around gives me lots of.mounting surface for things like ezb and other electronics.