Hello all @Rich, @Richard R I am aware of what all you guys are saying, I did the firmware update first, and that's when it stopped working. Its connecting, but the servos stopped working. My firmware is at 16.6....this is the latest right?

I'm quite sure the firmware update was successful...got all the way to recycling the board's power. The board works, and connects (faster btw) Any theories?

We have no immediate plans to stop supporting the v3 in ARC or EZ-SDK. Many of the new features of ARC are unable to run on the v3 due to processor and hardware limitations. However, the v3 will always remain compatible in the software.

In fact, we have released a few firmware updates for the v3 recently.

Yes, the v3 has been discontinued for production in April 2013 (over one year ago). We spent the last year developing the v4 and decided to not sell the v3 during the development time of the v4. This is because we did not want people to buy a v3 and be disappointed when the v4 came out. We gave our community the opportunity to purchase and wait for the v4 - which, as you can see was a wait worth while!

As for your servos not working, I recommend checking the fuse. If it has been a while since you last used the EZ-B v3, maybe there was an accidental short in the wiring of DOOOOOOOOOOM BOT. Can you use a volt meter to verify there is power between the GND and +5 Digital Pins of the EZ-B v3?

OK