Asked
— Edited
I'm totaling up the cost of supplies for my rad and I realised that there aren't any heavy duty or micro servos in the shop. what's going on?
Irobot Roomba Legacy
— Legacy iRobot Discovery and 4xxx control via EZB software-serial (D0), supports Arduino/EZ-Robot, adjustable baud rate; not for hardware UART/USB
Try it →
Out of stock - we are in a transition of suppliers and new products. Patience
ok no problem. any time range they'll be back? also the ez-b is out. when should it be back in?
Secret, the EZ-B is being replaced with the EZ-B v3 Mini
Sssssssssssshhhhhhh
Nice. I hope you don't accidently let it slip about when that'll be available
WOW DJ i cant wait,was asking about this for a long time ,have a few robots i started on my EZB we have now is too big.
STill think you should sell the order board,one reason if the chip gets fried can be replaced easy ,but on surface mount it cant.
Also DJ about the surface board you made and photo of it,how is the fuse replaced and will it have heatsinks.
I will not be releasing any more information about the EZ-B v3 mini until it is launched