Feetech Serial Bus Servo icon Feetech Serial Bus Servo — Control Feetech SC serial bus smart servos via EZB UART or PC COM port with ARC virtual ports, speed, position, release, and acceleration. Try it →

ARC Pro

Upgrade to ARC Pro

ARC Pro is your gateway to a community of like-minded robot enthusiasts and professionals, all united by a passion for advanced robot programming.

#1  

How are you providing power ?

Author Avatar
United Kingdom
LinkedIn Twitter Google+ YouTube
#2  

Check it's wired correctly. Check the power to it is 5V (or less). Check the config of the control is set correctly.

#3  

Can you take a picture of your wiring to the ezb board? Check and see if you have it wired correctly...

*** Important do you have the inline voltage regulator installed?***

  1. Power = Red pin D0 (voltage reg'd to +5V)
  2. Ground = Black Pin D0
  3. Trigger = D0 (white pin)
  4. Echo = D1 (white pin)
#6  

In the second picture you have the ports reversed from the first picture (trigger and echo)... how about your wiring..? Is it connected to the EZB like my example above? (see post #4)

Author Avatar
PRO
USA
#8  

I think I have the wiring correct, posted a close up photo