This is the most updated model of the LEVi Platform
By jstarne1
— Last update
Discover more robots
Luis's Using The Sure Dc Ss503v100 With Ezb4 From Ez-Robots
Connect Sure DC SS503V100 compass to EZ-Robots EZB4 via UART: RX/TX wiring, set OPT high to 3.3V, 4ft wire tested,...
Daman's Yet Another Wall-E
Compact Wall-E build with EZ-Robot: webcam eye, continuous servos, EZ-B mounting, servo speed control and tips for...
Animator28's AVA (Advanced Visual Android)
Human-sized open-source 3D-printed humanoid robot AVA with free Thingiverse files, built on the EZB platform, seeking...
While waiting on the drawer to print, I started slicing up the main body into printable pieces. The main body is 14 pieces and the top cover is 4. The rear drawer was broken into two sides that are printing now.
https://www.thingiverse.com/thing:4031686
For development purposes you are welcome to print along and make your own if you have the patience.
non commercial use only, for personal use and you may contribute with modifications for your own use, if they are cool enough we could make them official.
the two drawer halves are printed after 34 hours and a heart attack because I thought I was going to run out of filament. I noticed the rear looks like butt cheeks of the robot.
The number 1 and 2 pieces of LEVi are printing. These are the pieces that the rear drawer butts up to. You can see the rear tail light support if you look close enough. These should finish in about 5 hours.My bday is Fri the 13th this year!
Just do me a favor Josh and don't go near Elm street
But but but, that’s my street:(