My robot friend aRTi began from about 20lbs of PLA. aRTi is a work in progress. I built aRTi to learn. There is a future in AI and robotics and I want to be a part of it.
By IntellamicroRobotics
— Last update
Discover more robots
Joseph4760's Project X-Men Juggernaut
Merge an MGA-1 Quadtrax with a Robosapien torso: hack the circuit, remove canopy, mount torso, run on EZ controller then...
Laurin's My Head Designed For Jd
JD head redesigned to add ultrasound sensor and gyroscope space; hip gait refined for a more humanlike walk. Thingiverse...
Nallycat's Big Nallycat A Large Version Of Open Cat
3D-printed Big NallyCat (OpenCat variant) using PET-g for durable, low-infill parts; planning full-size servos for...
Hello! Welcome. This is the place to be for robotics. Nice looking Inmoov, you'll find lots here. You've spent a bit time post processing the face.
Can you share what you used for the eyes? They look great.
Hello 3dGuy,
I purchased the eyes through amazon. I tapped the pupil to allow for the EZ-B v4 Camera.
Pair of Realistic Acrylic Eyes for Halloween PROPS
Thanks,
Mark
Thanks for the link. I didn't know you could buy them like that. T-one may be getting some new peepers.
Looks great and a nice tip on the eyes.
I think your inmoov eyes look cool, There is quite a few inmoov builders on Synthiam, if you ever need advice you will not have to look far. welcome aboard.
Your build looks good, and nice eyes! I see you have a way to go the complete your InMoov, enjoy. Have you or are you going to use the EZ-B controllers, there are a couple of folks on the forum that have converted over from the original Arduino build and never looked back. Programming your InMoov with the ARC s/w is so easy!