My robot friend aRTi began from about 20lbs of PLA. aRTi is a work in progress. I built aRTi to learn. There is a future in AI and robotics and I want to be a part of it.
More robots by IntellamicroRobotics
Other projects from the same builder.
Discover more robots
Robots the community built with Synthiam ARC. Get ideas for your next build.
Bumsteadsean's Sentrybot
Prototype Sentrybot assembled with Arduino Mega and Mini-ITX, stereo CCD cameras, digital rangefinder, GPS, wired...
DJ's Roli Rover Robot Chasing Red Ball
Control EZ-Robot Roli Rover with Synthiam ARC to chase a red ball using vision tracking for quick, entertaining...
Robot's R3 Roomba Control Using 5 Volt Relays
Control Roomba power via EZB + 5V relays, run SCI commands and sensor diagnostics using Synthiam ARC's UART terminal and...

Hello! Welcome. This is the place to be for robotics. Nice looking Inmoov, you'll find lots here. You've spent a bit time post processing the face.
Can you share what you used for the eyes? They look great.
Hello 3dGuy,
I purchased the eyes through amazon. I tapped the pupil to allow for the EZ-B v4 Camera.
Pair of Realistic Acrylic Eyes for Halloween PROPS
Thanks,
Mark
Thanks for the link. I didn't know you could buy them like that. T-one may be getting some new peepers.
Looks great and a nice tip on the eyes.
I think your inmoov eyes look cool, There is quite a few inmoov builders on Synthiam, if you ever need advice you will not have to look far. welcome aboard.
Your build looks good, and nice eyes! I see you have a way to go the complete your InMoov, enjoy. Have you or are you going to use the EZ-B controllers, there are a couple of folks on the forum that have converted over from the original Arduino build and never looked back. Programming your InMoov with the ARC s/w is so easy!