All Community Content

Can I Use A Lo Tiny With Qunqi 2Packs L298n Motor Drive Controller Board Module

I have looked at the instructions on Hbridge in tutorials. I was wanting to use a Li Tiny but the instructions on the plugin uses a EZ-B 4-2. The EZ-B 4-2 has more ports and the instructions are calling out for higher numbered ports than Lo Tiny has. What do I need to do to use Lo Tiny. Here is the link to the Hbridge I want to use....

Speech Phrase

When comparing phrases recognized by the speech recognition with the string I typed in, the result was always false. The reason is the following: If a speech phrase is recognized it is stored in the variable with lower case letters even if the phrase was written in the wait for speech command with a mix of lower case and capital letters.

Enabling And Disabling Trained Objects Using A Script

Hi, I'm wondering if there is a way to write a script to select and deselect the objects that I have trained. I know how to have a script enable and disable Object Tacking, but I can't figure out how to have a script to automatically select and deselect the trained objects that have been saved, so that I can have the camera only track the saved...

Why Doesn't This Script Work Any More?

I have just switched over to the new 3 port Ultrasonic Sensors and this script will no longer work. It's the one I used for the 4 port Ultrasonic Sensor. The script always Prints 2 no matter how close I get an object to the sensor. $Center = GetPing(D11,D11) $close = 40 :start if($Center < $close) print(1) else Print(2) endif Sleep(2000)...