Robot Building Questions

Unable To Load Project

I am getting really nervous because I have been working hard at building a chat bot the last 4 weeks and continue to save as normal. This morning I tried to open my FRED project and an error window came up.. Unable to load "Object reference not set to an instance of an object" The last script I was working with was the Sound Movement...

Aforge.Net Conflict With Sdk

How can I use the latest version of AForge.NET side by side with the EZ-Robot SDK? Since the SDK has an aforge.dll and already uses AForge, I get a conflict when I try to include the actual AForge.NET dll's in the same project. I've tried using extern alias to separate the two in my own code, but still get the conflict. I believe extern alias won't...

What's On The Horizon?

I curious what hardware / software additions or improvements are in the works for 2013? Anything exciting on the horizon?

Kit Servos And Power Ratings

I haven't yet received my kit, but I am beginning to plan out my robot. I'm building off an existing vintage chassis like most folks. This chassis includes 2 small DC motors and gear box used for its drive train. They power wheels that are roughly 2 inch (5cm) in diameter. This robot weighs just about 7lbs (3.1kg), and may weigh slightly more in...

Camera Mods

Hey guys, ive seen a few posts where people have said they have moded the ez camera to run off the ez board / main power supply, and removed the need for a power switch etc, but cant find any details on how to perform them. Anyone got any details on how to do these? Or even better a video? Cheers Matt

Found Fairly Cheap Way To Cut Plastics

so that it wont melt and give a good clean cut i just bought a NO MELT plastic cutting saw blade for $90 for my table saw they make in all sizes and for hand circular saw another way is to get a wet saw and add very cold water or attach a small compressor out of a refrigerator,like i did for my work what make plastics melt it the blade gets hot and...

Dream About D.J. Last Night

I had a dream about D.J. last night. He walked up this very tall mountain where he opened the door to his office. He went inside. When he came down the mountain he was dressed like Moses. He had a white beard and Long white hair. He was carrying two tablets with the EZB Scripts on them. He appeared to have gotten even more smarter. ..... then I...

For Sale Section?

Hey, I was just wondering if it would be a good idea to have a for sale / wanted section on the forum? I'm after a few bits for my robots and I have a few things to sell aswell. I've been recommended people to speak to about parts when they come up during a conversation in a thread, but it could be cool to have a place to specifically ask for...

Rover 2.0

Does the ez software support Rover 2.0? I was planning on ordering the ex kit and the Rover to go with it, so is the latest Rover 2.0 version supported?

Need Help To Setup Full Serial Interface Without Using I2c

Another posting brought up the request for ARC based interfacing to Aurdino boards. Understandably it is not going to happen as they require their own not-so-ez-programming. I still feel that full interfacing of the EZ-B to all other electronic devices can be beneficial, regardless of said devices origin, LED, sensor or another micro-controller....

Can I Modify Movement Panel Configuration Via Joystick Buttons?

I am attempting to have the EZ-B control the OWI-535 arm. There is only one movement panel allowed. This should be fine provided I can reconfigure the movement panel with the script triggered by a joystick button down script. Is this possible?