-635143705157812500.jpg)
update 9-9-2013 added pics of the sparkfun mp3 trigger and installation.
check it out! I have added body tilt, forward back, left and right.
By hoolagen1
— Last update
Other robots from Synthiam community
Lumpy's Lumpy's Roomba Rover
Hey All! Picked up one of those cheapy arduino wheeled platforms. It came with those cheesy yellow motors and yellow...
Steve's 2 Ft Biped Walking(Shuffle) Robot
Omni wheels I purchased the parts for this project over 9 months ago, and got going on it about 3 months ago. I am...
Ezang's New Update Mr. Roman
Hi, This is Roman, I am updated - Hi Dave Schulpius and everyone else :-) I am back, if I talk to fast, I am from N.Y....
Sup troy,
I used your set up for the body tilt. Thanks again for all the pics and advise on your thread! The only problem was the body is much smaller than the u command wall e, so I placed all 4 servos under the body instead of inside.
I will. Set up the rest of the servos and show off all the point of movement.
3 motions in the head (4 servos) 1 neck in and out motion (1 servo) 2 motions in each arm (2 servos per arm) Body tilt and wheels.(4 servos) Plus a smoke sensor / 2 ir sensors / mp3 sounds and LEDs
Trying to break into the top 5 of tricked out wall-e's on the forum!
this is the head and neck motion
Great job. Im glad you were able to improve on it. We all are learning from each other. You have a lot of movement in the head and body. I love it. Again great job. All you need are some dance scripts.
I concur with Troy! ......very cool Wall-E which I will be following!
adding sparkfun mp3 trigger i cut some slots on the top of the body for the main switch and access to the micro sd card.
first some pics of the wall e
now some pics of the slots that i cut
now some pics of the mp3 trigger board in the body
and finally some pics of the micro sd card and main button "popping" out of the slots i cut.
Smoke sensor and "all movement" video coming up.
I love robots!