I posted this in the wrong section I guess, but here is a link to my newest bot - RoboRAD. I am combining a RAD 2.0 base and a robosapien.
LINK
By bret.tallent
— Last update
Other robots from Synthiam community

Dunning-Kruger's My Inmoov Bartender
Well after seeing Bob Houstons inMoov (hard act to follow by the way) on here a while back I knew I had to make one too....

Lemon's Galapagos Mode- Scorpion Tail
I rebuild my Tortoise bot all the time and this is my short leg version with a scorpion tail. Just sharing enjoy.

Cardboardhacker's Technopro Wall-E Project
I have finally started my wall-e project. I have desided to keep it simple due to my lack of income at age 12. I have...
Thats cool bret! Where did you get your stickers?
Pretty cool Bret!
Thanks guys. I just got some self adhesive vinyl sheet off ebay and cut the letters out with an xacto knife. Stuck those onto the silver sheet and cut around that with scissors.
not great in ART ,BRET are you able to make me a set
Second i took apart the robosapien with the claws to replace a cable on one of mine,and another i found out that arm motor gear was bad,it was a broken robosapien off ebay
WHEN i took the claw apart i found out not same as robosapien v2,so no mods can be done Also if you or anyone else needs parts like main pcb still good ,and other motors and stuff ,i can sell the parts cheap
Bret i tore down robosapien model like your's and found out there is a another modify you can do easy
IF you look at the motors gear box they are using its a POLOLU GM-2 gear box,and the motor can be change for a higher torque motor very easy its a RM-2,but you will need to upgrade the H-BRIDGE
BRET my friend i finally got my plasma ball came in today,wow over 3 weeks from china,i bought a lot of stuff from china from same area and after i ordered this one and all came in fast,and was the china holiday time
not shore if i will ever buy from his store any more
BRET another question on your plasma ball ,before i leave for a big party i am going too is your's also sound activated also
THIS week looking to cut out the holes in the rad base,for speakerand plasma ball and laser light show
BRET another question since i building something close to your on the plasma ball hole you made .did you make it the same size as the plasma ball or did you just made a little smaller and put the ball from the bottom. hope to see a photo of the bottom of the rad base on how you did it
Since w hen i took mine apart to work on the circuit board it is bigger then the ball and the plasma ball could not be removed.
one i have uses also sound and i made 2 simple mods ,one i took the microphone out and added a audio jack to it,second on the switch i made a small mod to switch from audio to manual using EZB