Robot Building Questions

How Do I Make A Servo Move Up And Down In A Continous Motion??

I want to make Wall-E head move up and down but in a continuous motion using script, is this possible? that is the servo is not jumping from specified servo position to another and skipping all the in between positions, sort of like how you would slide the servo control slider up and down. Is this even possible using script? I want to create some...

Suggestion: Add Text Search Box In Script Help Window

I want to suggest adding a text search box at the top right of the Script Help window or add support for Control + F for text search. This will make it a lot easier to find the function you're looking for by entering a search term and press enter, much better than scrolling thru the list if you already know what you want and just need the command...

Can The Ez B Do This

I've got a light control board that will send different light patterns to 10 number 47 incandescent light bulbs. To activate the patterns I need to ground 1 of the header pins on the board. The pattern will stop when the ground is removed. There are 2 rows of headder pins. 1 row is ground and the other activates each pattern. I can use a simple...

Question With Connection After Successful Firmware Upgrade

Upgrade of firmware was successful with note to restart. I unplugged the power and plugged and after this, blue led slowly fading and again light on still around, red is blinking without the possibility to connect to the free COM7, which i used for firmware upgrade. I see the EZ-Robot as BT Device, but I am not able to connect. Thanks for your...

Unable To Establish Bluetooth Connection

Just got my EZ-B - I have tried different computers and and the controller cannot be discovered. I know the laptop is fine as it discovers other bluetooth devices - anyone can help?

Just Got A Major Score At The Thrift Store

when in to goodwill thrift near my house and found 2 robots one was tthe small OMNIBOT in box for $15 and a RAD 2.0 no remote for $7 most these robots are hard to find on ebay or very high cost more hacking time

H Bridge Voltage

Can I feed the h bridge sold here with 12 volts dc? From what I have read it will only take 5 volts. Thanks, Dave

To Sfoy About Denise

I forgot to tell you that you can purchase the $100 version of Guile3D Denise and upgrade to the $180 later by just paying the balance. Pretty neat. If you decide to buy, don't forget to tell them that Mel (MovieMaker) sent you. They have been very good to me, and I want them to know that I appreciate it by spreading the word. Don't expect for...