This is the thread for my current project Dewy. He is a tall robot that uses RAD parts and models a omnibot in a way.
For showcases sake:
Here's the process of tearing down the RAD.
Here's where I finished off.
By CardboardHacker
— Last update
Discover more robots
DJ's Robot Blinds Control
Control deck blinds from your phone with a simple DIY setup using hot glue, wood screws and 2x4 scraps.
Oakmot's Chloe Project
Home mannequin robot using EZ-B servos, camera face-tracking and Synthiam ARC control with DC power, arm plans, and...
Justinratliff's Jd Backpack
JD backpack mockup anchors into JD's middle slot with male clip, two top posts, dual rear mounts, wire access and switch...
He's starting to look like I want him to look!
Working on arms(foam) today. Hope to finish them!
looking cool.what color will you use?
Not decided yet. Check out the paint scheme thread.
Here's the final paint scheme sketch. Thanks Cupcake for the help!
And as I posted in my paint scheme thread, I think ill put the ez-robot logo in the chest hole of the rad body on some clear material and will have light shining outward.
I hope to make the arms this week(dummy arms, but might make work later) out of insulation foam.
Loving the stripes. Very Mass Effect/N7 -ish.
video update coming soon!
Update Time!
Minor update.
I'm back to work! Right now I'm doing body work smoothing out the rough spots and trying to align the items that are angled. Another update soon to come!