All Community Content

Ez-Board Auto Disconnect

Just wondering, is it possible to shut off the Bluetooth auto disconnect? I'm going to be running the board as a controller for two servos that will move a distance sensor. This means the board will not be receiving commands constantly as I will need to communicate with the sensor. If it can't be shut off, is there an option to increase the wait...

Compass, Gps

Can anyone advise on some cheap addons for me to add GPS, compass and a gyro to the board

Shiping

Do You Ship to Faisalabad , Pakistan , Asia. 38000. Or Islamabad , Pakistan , Asia. 44000. Also Tell SHiping charges for both Cities. I am getting this error. Please fix these errors: Cannot verify your shipping information. Please review your information.

3 Pin Fan

hi i am using a 12v power supply with my ez-b i started to get i little hot so i bought a 5v cooling fan for ez-b but my fan has 3 pin instead of 2 it has an extra signal wire does this make any diffrence i am thinking of connect fan to lets say d1 if i write set(d1,on) it should turn the fan on right?

Bluetooth Help

Hello,i have this Bluetooth dongle bluetooth And i need to do the initial install of the firmware.the weird thing is i does not find the ezb at all.but it can find my smart phone, and my phone in turn can find the ezb. I am using the windows Bluetooth stack.the USB is windows 7 compliant.i tried everything i can think of, rebooting, changing USB...

Matlab Control Of The Board

Hi, I'm currently working on a project where I need to be able to control the EZ-board through Matlab. I've managed to connect to the board over Bluetooth using Matlab, but I'm now stuck on the syntax and commands I need to use. My questions are: 1- Do you have a list of the commands that are used in the ARC ? 2- What terminator charracter does ARC...

Camera Recording

Can I record with he camera that comes with the ez bot kit

Usb-Ttl Serial Cable Connection Question

I bought a Roving Networks USB-5V Serial UART cable (RN-SRL-FTD5V-CLR) from Mouser Electronics, and added a header to it for TX, RX, Gnd connection to EZ-B. And yes, I am connecting Cable Tx to EZ-B Rx and Cable Rx to EZ-B Tx. The connection to my desktop PC was plug & play. The device manager shows the Cable in Com 8 with 9600 baud rate, 8...

I Am Working On A Wifi And Wired Network Design

I am designing a circuit to use both WIFI and wired network i found a WIFI board that has network signals (I/O) that are called PH ,2 FOR transmitting and 2 for receiving and needs a special RJ45 with a isolated transformer and tiny circuit (a few resistors) one main reason for me is i have a few freshwater tanks and saltwater tanks and gecko cage...

Rj45 And Ez-B

Hi there I need to use wired lan (RJ45) to control my ez-b on a long distance. I've searched the forum for solution but haven't found. How can I replace the bluetooth with wired lan and how long RJ45 cable can I use? I've read that RJ45 could be up to ~90 meters (295ft) but will ez-b be able to read the signal at that length? Thanx

Camera Hacking

i need to hack my ez-cam for my wall-e. i noticed that it is a little different from the one in Dj's video. does anyone have a pic or diagram for where to connect the signal cable/wire?