Robot Building Questions

Additional Hardware Help

I'm just wondering if anyone knows if these can be connected to the ezb board: https://www.robot-electronics.co.uk/htm/tsa01.htm https://proto-pic.co.uk/tmp36-temperature-sensor/ https://www.robot-electronics.co.uk/htm/cmps3tech.htm https://www.robot-electronics.co.uk/datasheets/uCAM-DS-rev4.pdf...

How Can I Use Multiple Modified Servos?

I have two kits I am trying to run all four continuous servos Only can get two to run

How Do I Use Ping Radar Control?

I must have a bad board, I cant get the radar to work or the ping sensor to work, i've tried different ports and to no avail. That bums me out cause everything else works, what do I do?

Scripting

Hello, I've been working on my EZ BoxBot from the tutorials, and have gotten all the way through the videos. However, the tutorials stop after showing how to make the wheels work, and so my robot can't move its head or arms at the moment. I've been trying to set those up, but I'm unsure of what I should be doing. I tried clicking on both...

Where Can I Find Larger Servo Wheels?

Where does one get bigger wheels The ones that come with the kit are real small really limits your build

Hi All, First Post And Few Questions

Hey everyone, I need to build an autonomous robot that would serve the function of a mini fork lift. I have researched lot of kits/options and have decided to go with EZ-Robot. I been lurking on the forum for last week or so and the live and helpful community is one of the primary reasons I have decided to choose EZ-Robot I am currently trying to...

I Received My EZ Robot Kit Last Night

Been playing with it ever since. Anyway I am having some issues. I am sure these are operator errors not problems with the gear In any case I ran the servo calibration example on all the non modified servos No I am trying to make a head move left and right using the horizontal servo tool in add control I have it on D0 When I look at it it shows min...

I2c Lcd Displays.

I've searched here and google and found information on I2C but what I think I need is an idiot's guide as it's all a little beyond me to be honest. Basically I received my LCD today which I thought was Serial but turns out it's I2C with the IIC backpack board (I believe that's the right terminology). Which I thought would be fine as EZB has it's...

How To Drive A Led Correctly From A Digital Output

SHOULD always use a current resistor inline with led ,so you dont damage the ezb digital pin or burn out the diode Here is a link for reasons why and formula to work out the resistor value. driving a led from a digital output

New Ez-B With To Wifi Module

Hi, I just received my UART-WIFI module from China which is fully compatible with ELECHouse module. Stackable Uart WiFi Module Kit Manual and Software are online same as ELechouse Module. I had two problems while working on it and appreciate your support: 1. The pin connectivity is not compatable with the existing BT module. this may require cable...