Robot Building Questions

I Am Getting A No Internet

I am getting a no internet message on ARC Mobile, despite following the procedure on The Robot Program 025. I am connected to the EZB-v4/2 in my Adventure Bot but when I try to get the Remote Control it doesnt happen. I do get internet on my phone through my WiFi network (I dont have a data plan on that phone). My PC has an Ethernet connection to...

Want To Connect A EZ-B V4 WIFI

Want to connect a EZ-B v4 WIFI Robot Controller to Meccanoid Servos using a arduino UNO. Need harware configuration. Arduino code. Sample code to drive the servos Thank you for help.

Is There An SDK For EZ-B That

Is there an SDK for EZ-B that would let me design my own Blockly interface?

Wondering Something

https://www.ez-robot.com/Shop/AccessoriesDetails.aspx?prevCat=9productNumber=14 298 h bridge I probably asked this question before but cant remember the answers from a few years ago I bought this H bridge,used 6 volt motors,for long periods of time outdoors,a really great product, just wondering about using for newer higher torque car window lift...

I Would Like To Call My Robot

I would like to call my robot by name. When using Speech Recognition, robot turn left or robot say hello can I use another name instead, like Sam say hello?  Ron

Let Me Ask: How To Control And

Let me ask: how to control and program each servo when serial connection them on a port?

:(Not Totally Sure But I May H

:(Not totally sure but I may have burned out the first i2c port 1 below the camera port, I accidentally touched the first pin there with the negative wire from a digital port in the bottom left corner and there was a burn smell I quickly disconnected the battery and all seems to be working with the EZ4 ( I had a flashback from 2 years ago where I...

When I Program With Blockly An

When i Program with Blockly and the Program is finished the arm servos go crazy and do anything. Please help me. PS: If its important. I have a JD Humanoid

Let Me Ask: When I Program The

Let me ask: when I program the servo with Ez-script language, I need to program BLOCKly and can guide me how to create them?

Is It Possible To Use A Wall P

Is it possible to use a wall plug to power an EZ-B v4? Is one available for sale?

Hello,I Am Working With A 3

Hello, I am working with a 3 phase speed controller for my robot leg project. In order to change direction of the motor I need to either send +5V to a pin or ground that same pin.  Supplying the 5V in not problem but how can I use EZB to apply a common ground signal to that pin on command? Perry