Robot Building Questions

Wheel Not Working Properly

Hi there, I have an AdventureBot where the wheel only turns in one direction. I have tried the following: - swapped out motor - switched pin input Any ideas on next steps? Any advice would be great - supposed to be taking it to a show in two days...

Hbridge PWM Only Working On Board 0.

I am not sure whats wrong.  But I've noticed that PWM controls are not working correctly, they sometimes loose connection with the port.  Also I cant seem to get the Hbridge with PWM to work on any board except 0.   Has anyone else had the same issue?

Ez-B With Computer Vision

I apologize if this is a redundant question: but with EZ-pi software used for EZ-b, raspberry pi, does the camera system support identifying and counting objects like computer vision in opencv ?I hope that is possible https://opencv.org/

Servo's On Second EZB

I am running two EZB's on my project.  The second one has two servos connected.  When I run the script command getservo(1.12) or getservo(1.13) it returns zero until I actually issue a move servo command and then it will show the position of the servo.  Has anyone else noticed this issue?

Auto Connect To Router

I set my robot to Client mode yesterday for the first time and everything worked fine. Today I loaded ARC, turned on robot and the Ezb had changed to Ap mode.  Do I, every time i turn on my robot, have to set up client mode again?

STL Doesn't Match Print

i printed the backpart of a lever servo,and i notest the file is not correct with the print? i notest some other parts doesn match.