Hello forum
may i have some help please?
I have a question about HC-SRO4 sensor.
The sensor works on 5V DC on digital ports and working current: 15mA. The output voltage on digital port on EZ-B V4 is 7,4V.
The question: It is necessary to use a DC-DC Step down Buck Converter?
By sakis33
— Last update
Other robots from Synthiam community
Redzone's Gideon Inmoov
I have not been here for sometime been busy with that dirty word, work. I have ,however, been redesigning my bottom half...
Dave's Bimbo The Clown
Wow! What fun! DJs Bimbo The Clown is a gas! I really love these old amusement games and EZ Robot really breathes new...
Crivellarodiego's How To Automate The Robot
Hello I state that I am using the product from very little, I would ask how I can create the project in ARC for the...
Depends where you get it, are you referring to ezrobot’s Ultrasonic Distance Sensor or one from another source?
The one from ezrobot (Ultrasonic Distance Sensor) includes embedded electronics to handle the voltage lowering for you. I can’t speak on ones from other sources because they most likely do not include that circuitry.
Hi Dj and thank you for the response
it is not from ezrobot , it is from another source and it is not included voltage lowering circuit.
the values that i get from the sensor it is not "stable"!
You will need to step down the voltage if its not the ezrobot one.. I am using a Buck Converter for 2 additional after market sensors. I bought a hand full of cheap ones of ebay but you get what you pay for... some of them are junk.