cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Other robots from Synthiam community
Justinratliff's Ez-Robot Bb-8 Hexapod Body
I made a BB-8 hexapod body to go with the head. You can use the mountable head with the EZ-Bit I made: Or you could...
DJ's How Do I Shovel My Snow?
With a robot, of course! What did you expect? This is a robot shell that I built with some students in the summer for a...
Ezang's My New Update Arm Robot 11/14/2019
My new update to the Robot arm, added a 5th servo to the gripper - using auto-position - Ez builder software and Ezb4...
Ok taking a small break from these treads that are stressing me out , I need to do cutting so I'm marking everything on.the torso and wheels where I need to cut the V groove and I need to knotch out the torso as well so there is room for the Dvd / blueray drive below the power management panel.
I believe I will also mold in the bezel for the fan / temp controller , this will cover up some labeling but it will also make it look cleaner.
@robotmaker , no I don't have a way to measure torque but I did test voltages between 6v to 12v the sweet spot felt like 9 volts.
way to measure payload handling (torque) is after you finish the tracks or if you did it before, is run the motors and bottom chassis only and add weights till is comes close to stop
Ok I took apart the fan controller , and flushed it into the torso cutting knotches , I with glue all the way around with epoxy and fill with body filler.
None of the mounting.points or button are obstructed from what I see here in the test fit.
Ok I cut the torso to accomidate the Dvd drive , I attached a ledge where the Dvd drive will be held with double sided tape. I will cut a piece of wood to affix on top of the drive to give me additional mounting space for electronics.
It's black so it doesnt show well however the dvd/blueray drive is in place above the fan controller
. This couldn't be fitting together any better
on my omnibot 2000 i finally tore it down and removed all screws,metals,electronics ,gears and motors out of all the plastic parts ,next is to wash it,bag it and box it for latter also researching motors,servo's and other parts needed and then order them,so when i finish my other 2 builds it should have the parts in by then i did have plans to work on RAD 2.0 but the little guy will have to wait its turn OMNIBOT 2000 want more
Hopefully you won't show me up and outdo my.omnibot 2000 lol
it may,using TPA81 SENSOR
Paint is coming soon