#d Printer

Question

Hello all,

I have a 3D printer and would like to know if I can add it to help people print if they need the service. Most cases I am willing to trade for help programming, since I am not very good programming yet. stress

CochranRobotics · Answer

From here Check the check mark that says Join the 3D community Also put down what type of 3D printer you have. Save your profile, and then people can find you when they would like something 3D printed.

Redzone · Answer

Hi D. I don't see that? I must be blind.

Redzone · Answer

Found it d. Thanks for your help.

DJ Sures · Answer

What is a #d printer?

Redzone · Answer

My bad DJ. It should be 3D printer. Can you fix my error? PS keep up the great work!

Luis Vazquez · Answer

Where in the US abouts are you .. i would be interested in some printing.

Redzone · Answer

Hi Luis, I live is Springfield, OR I am currently printing the Inmoov robot and plan to use the EZ-B V4. I have the basic prints completed, torso, hands, forearms and shoulders. What would you like printed?

DJ Sures · Answer

Thanks man! I was bugging you It's been a while since we chatted

Redzone · Answer

Yes it has. I've been busy with my new job and haven't had time to learn the ARC. I was getting the hang of learning EZ-B it back in 2012 and 2013, however, when you programmed EZ-Bit even more powerful with all the great stuff, my head started to hurt learning the new commands. confused

I plan to start learning EZ-B again soon, Now that I have a little more time to play. Thanks for all your hard work and help and don't forget this community! I plan to start your tutorials too.

Redzone · Answer

Plus, it is I that bugs you and the community, I always ask for help. So offering my printer is a way to give back to this site for all the help I get as I am not as active as most on this site.

Redzone

#D Printer

Upgrade to ARC Pro