pranav
India
Asked
— Edited
Resolved by jstarne1!
I am interested in building an Omnibot 2000 or Omnibot 3000 from the scrap... Using fiberglass... But I would like to know which motors shall I use to bear the weight (about 12-15 Kgs) and drive them... I would even prefer some suggestions on which motor driver compatible to EZ-B to be used... Guys, please guide me in the same...
I once had motors that looked just like that. I went to the junk yard and got two windshield wiper motors used. They worked good on my robot. But, it was 12V and it was in 1978.
Sorry to waste the post but I want to watch this thread and I don't know of any other way to subscribe to it for the update email.
I made my robot with normal foam board... So it's not that heavy... I used an L298n motor driver and now it works perfectly fine.. But all the replies to the forum are very useful for anyone looking for heavyduty motors and controllers...