Redzone
USA
Asked
— Edited
Resolved by Rich!
I broke one of my EZB4 boards and was going to temporally use my EZBv3 with EZB4. I know I can connect both. But when I do it sets the calibration to 50 and not 90 as the EZBv4 every though when I only connected EZB4.
Is there a way to connect these 2 boards and not lose my calibration from my EZB4 board? I hope I explained this right.
Thank you all.
@Antron007, I tried what you suggested and it will not work. I'll just wait for my new V4. Thanks.
@Richard R, Good one.