-636459989693042832.jpg)
-636459989943960739.jpg)
-636459990485479714.jpg)
-636459980560649389.jpg)
-636459975718038038.jpg)
-636459969210457653.jpg)
-636459967995726605.jpg)
-636459970865108143.jpg)
-636465120384538626.jpg)
-636465113490053830.jpg)
-636475595612490698.jpg)
Here is the current look of this project, Super cool update, magpi magazine wants to feature this build with steps how it was done , !
By jstarne1
— Last update
Discover more robots
Bhouston's Inmoov's Touch Sensors
Build DIY touch sensors for robots in Synthiam ARC using foil tape on an ADC port and simple scripting.
Ezang's Mr. Big Bot For You See Laugh And Enjoy
My New Robot offers fun, entertaining demonstrations for you to see, laugh, and enjoy
Dunning-Kruger's Ez Dog (Inmoov Frankendog Failure)
Failed experiment prototype; planning a new version with design improvements and fresh ideas.
Kinda excited , I am suppose to get the big order I put in tomorrow ! Woop Woop !
I still need to find a way to weather proof the motors , wiring and electronics.
How about stuffing it in a Hefty Bag? LOL
It won't help with the motors, but you could pot the electronics in non-conductive silcone. Pretty permanent solution, so be sure of your design before you do it.
https://en.wikipedia.org/wiki/Potting_(electronics)
Alan
Hey thanks for the idea. I have been watching youtube for ideas and I found that Plastidip can be sprayed onto electronics for waterproofing , but if you even need to get it off the board, it is possible to pull it off. ( usually not in one piece but its possible)
https://www.youtube.com/watch?v=dIOU7iwLWrE
Spray Dip a motherboard in white ! I might actually do that since I love white so much.
Your GPS tracker maybe a challenge in future as a lot of the GSM networks that provide this service are shutting down. If you have an old android phone laying around maybe you can stick in a twillio sim and track that.
Yes a android phone hidden inside is certainly an option if this does not work out. I know att and Tmobile as well as straight y’all still support 4 channels of gsm but they no longer support EDGE internet speeds which utilized those frequencies all at once to make a 128 kB data connection.
I started to disassemble the chassis , I can see there are certainly differences from the other one and I think I may swap the front end so I can easily find a place for headlights. The screws on the fender are badly rusted and I put some for in the hole to break it up.