MPU9150 Accelerometer, Gyro, Temperature, Compass icon MPU9150 Accelerometer, Gyro, Temperature, Compass — MPU9150 ARC control reads compass, gyro, accelerometer and temperature via I2C, initializes and sets EZ-Script variables on demand. Try it →

ARC Pro

Upgrade to ARC Pro

Unlock the true power of automation and robotics by becoming a proud subscriber of Synthiam ARC Pro.

#1  

What H-Bridge are you using for the stepper? A lot of users have had problems getting steppers to work with EZ-B, although @bookmaker32 figured it out with a little additional circuitry. See post 14 in this thread: synthiam.com/Community/Questions/6183&page=2

#2  

It's a L298N H-bridge.

#3  

Haven't we had a discussion before on whether or not an H-bridge would work as a motor controller for a stepper motor?... I was under the impression it won't work or was at least a good challenge...

Wouldn't it be easier to just use a basic servo for your steering mechanism?

#4  

After further digging I believe you're right @thetechguru. I'll play with it a while and if that doesn't work I'll go the servos.

Thanks to both of you!