I set my robot to Client mode yesterday for the first time and everything worked fine.
Today I loaded ARC, turned on robot and the Ezb had changed to Ap mode. Do I, every time i turn on my robot, have to set up client mode again?
Ellis
USA
Asked
1 Participant
Auto Connect To Router
Related Hardware (view all EZB hardware)
EZ-B V4
by EZ-Robot
EZ-B v4 with Synthiam ARCx controls servos, sensors, camera and audio over Wi-Fi or USB serial, no firmware needed.
Wi-Fi / USB
Servos
24
Camera
Audio
UART
3
I2C
ADC
8
Digital
24
Related Robot Skill (view all robot skills)
EZ-B Settings
by EZ-Robot
Configures and pushes WiFi SSID, password, system name and channel to EZ-Robot EZ-B v4 from ARC; saves settings with project for quick redeploy.
Requires ARC
v6
No. Mine have stayed in client mode for years, often months between being powered on. Are you sure you didn't hit the reset button?
Yes. I would have to be pretty intentional to reset the controller. I don’t think I could do it accidentally but thanks for the help. I am going to change it again and see if it holds. It is good to know that it usually holds.
I found out it was connecting to router. I just thought it said it was not connecting and the IP address was wrong.