All Community Content

Mecanum Wheels Movement Panel

Hello, I know there is another post by another EZ-Robot member but it had no answer. I would like to use two H-Bridge motor controllers simultaneously to provide my robot (custom built from meccano) with 4WD functionality AS WELL AS side to side and 360 degree movement. I know this can be done with omni wheels but I would like to be using MECANUM...

Need Help On Hbridge, Please

OK, I have: Left trigger A 16 Left trigger B 17 Right trigger A 18 Right trigger B 19 When I hit forward, it goes to the right. when I hit backward, it goes to the left. when I hit Right it goes forward. and when I hit Left it goes backwards. How can I fix this? Thanks in Advance.

Gyro-Sensor Compatibility For Ez-Robot?

Recently as part of my humanoid robot project, I want to use some gyro sensors to balance the robot's body.Is it possible to use a program within the EZ-Robot software so I can use them besides accelerometers and such?

Question About Mimo Monitors-Anyone

As you know, I was planning to put a mimo monitor on Sunshine's chest. I just got it in yesterday. I installed the drivers on the desktop and it looked good. I installed the drivers on the netbook that I was going to use with the EZB. It is an Acer ONE netbook. When I installed the drivers on it, I set it up for Landscape to start out with. That...

For Aameralis

Hello, my friend. When you were using the omnibot base on Lexi, did you run into a situation of when you turned on the EZB, she would start going backwards? That is what I am facing. When she is going backwards, since the robot base is put on there backward, that would be forward. Now, this is with the EZB hooked up , but not connected. Share any...

Toy Wall-E

I WOULD LIKE TO KNOW EXACTLY TOY USED DJ SURE, AND IF I SEND EXACTLY THE LINK TO SHIPPING would greatly appreciate it THANK YOU FOR YOUR TIME