Robot Building Questions

Defective Servo

One of my servos is overheating on my newly purchased EZ 6 Hexapod. I can smell the heat and see smoke coming from the part. How can I go about getting a replacement?

Common Questions For Reporting Questions

I just created some trouble reporting forms to use with the call center agents at work when they report problems to my team because we always need to go back to them and ask questions to clarify what the issue is. I see the same thing happen here all the time where someone will write a post tjat "x doesn't work" or "y crashes"...

Is It Possible To Ramp Up And Down The Brightness Of Leds?

No lucking finding a post on this. I am working on a BB-8 driod with the EZ-Robot and am looking to get LEDs to quickly ramp to full brightness and fade out the same way (as opposed to just turn on or off.) Any ideas on the best way to achieve this? Thanks, Bob

Script To Refresh Joystick

is there a command i can put in script to refresh the joystick ez panel as opposed to clicking the refresh button in the ez joystick window?

Ultrasound, Ping And Object Avoidancec On The Ezb-V3

Richard, would you know what script the Object Avoidance was for the v3. I have One PING unit with One sharp IR. . that's it. I just want to find that little algorythm. I used to know this site like the palm of my hand. But, I have forgotten a lot in the last many years. I am down to one robot, Sally. I finally scraped up enough to get some eyes. I...

Obvious - Dumb Question - 7.4V Lipo Pack - But Most Servos Including Ez-Servos R

I am going to ask a question that has been gnawing at the back of my head. I have searched around and I see yes's and no's. If a Servo is one of the many servos that gives you a torque at 4.8v and 6.0v And the EZBV4 pins are unregulated. Does the LiPo powering the EZBV4 mean that I need to only look for 7.4v servos?