Well it's never really complete right?
Here's my first (whew!) fully working droid, "Archetype". As you can see its somewhat EZbit "friendly" so room for expansion is possible.
I hope you all like my style...back to the old way of doing things, without 3D printers. Having said that, I have to credit Richard R for the ezbits.
Enjoy, and comments and suggestions are appreciated!
As of right now, I can't use everything at the same time, since it causes the ezb to brown out. I have also done the super cap fix, although it helps, I still only have a 2 amp voltage regulator running everything. That's only temporary of course. Once I get a higher amp battery I'll post some videos.
By Doombot
— Last update
Other robots from Synthiam community
Mcsdaver's 3D Printed Ez Robot Bob
I forgot to click Robot Showcase so I am starting over here with Bob. Bob is my 3d printed EZ robot built with EZ-Bits,...
Steve's 2 Ft Biped Walking(Shuffle) Robot
Omni wheels I purchased the parts for this project over 9 months ago, and got going on it about 3 months ago. I am...
Ellis's Halloween Robot
Here is Robot Max and his helper Tele. Sorry I am late getting this out. Couldnt bet it to load. Finally put it on...
@Robot Doc , @JustinRatliff
Guys, I can't thank you enough! Working on the video! I'm just finalizing the drivetrain on this thing, so a few minor changes may occur.
Update: I found a cost effective laser diode that'll kick @$$.