I would extend the ez with parts that enable it to show basic awareness of its surroundings. Ideas could be temperatre sensor, CO2 sendor (when the air in a room is ''good'' or ''bad'' and give alarms when there is too many ppm CO2, such as from a heater or fire), water-sensor so that it would stop in front of a poodle, noise sensor to know when it is loud or quite (good in shools), light sensor and a basic built-in clock.
By with_joerg
Other robots from Synthiam community

Davidh's BOB
26th October 2023 He is a Standard (ish) Inmoov called BOB. Started on the 20th of October 2023, All printed so far with...

Ezang's Video 2 Of My Metal Arm Gripper With An Arduino And...
Video 2 of my metal Arm Gripper with an Arduino and Ez-builder software

Animator28's AVA Advanced Visual Android
Hello Again pheww the robot legs are done and ready to 3d print each joint uses a parametric slew motor which are driven...