I would extend the ez with parts that enable it to show basic awareness of its surroundings. Ideas could be temperatre sensor, CO2 sendor (when the air in a room is ''good'' or ''bad'' and give alarms when there is too many ppm CO2, such as from a heater or fire), water-sensor so that it would stop in front of a poodle, noise sensor to know when it is loud or quite (good in shools), light sensor and a basic built-in clock.
By with_joerg
Other robots from Synthiam community
Ezang's New Hand Progress, 3D Printing, Glyphs , Ultrasonic,...
Synthiam ARC controls multi-controller EZ-Robot with 2 Iotiny, 2 EZB4, HDD/996R servos, RGB eyes, camera and motor...
Robohappy's Adventurebot4wd
4-wheel drive robot upgrade using four CR servos with Y-splitter cables to preserve directional control; camera, sensors...
Jstarne1's Ladybug Lawn Mower 3D Designing The First 3D...
Ladybug-themed all-in-one mower and weed eater kit showcasing an integrated lawn mower and trimmer design.
