MovieMaker
USA
Asked
— Edited
Resolved by Robot Doc!
I originally posted this in the wrong place so here we go.
I have been racking my brain trying to figure out what is happening. I downloaded (about a dozen times) the EZ-Bits for the EZ-B3 card cover.
The plate printed just fine. But, the cover had a perfect shape, but it was sooooo thin. Have any of you experienced this before?
My 20mm cube prints good except for a little razzle on top.
Thank You Ladies and Gentlemen for your time.
No credit was gained from posting a suggested solution and getting my login user name applied to the member solution log. I did not even receive a nice email from the system.
@Rich, Thanks for that information. I did not know the post will close automatically.
@Robo-Doc, Look at the top of the page. It says:
Award Congratulations Robot-Doc , for successfully answering the question!
I am really having a time with my Extruder.
It seems that if I give it more shells, it just ignores that and prints very thin and brittle.
C-ya!