Netherlands
Asked — Edited

Ping)) Ultrasonic Sensor Question

My sensor only has a Vcc, Gnd and Signal pin on it, can i wire it with just 1 servo wire?


ARC Pro

Upgrade to ARC Pro

Subscribe to ARC Pro, and your robot will become a canvas for your imagination, limited only by your creativity.

PRO
Synthiam
#9  

Interesting.... Try it and see:)

It MIGHT just work! I'd have to look at my code and see what kind of magical spell I put on that function. Darn assembly:) It's harder to read then it is to write!

Netherlands
#10  

Then i will first need to receive my EZ-B, it has been sent +2 weeks ago but it hasn't arrived yet :(

PRO
Synthiam
#11  

Really??!! That's not good. Where are you? Did you receive a tracking number?

Netherlands
#12  

I'm in the netherlands and did not receive a tracking number :(

Netherlands
#13  

Wait, i did get a shipment number and when i entered it in canada post, the only status is:

2011/07/25 19:25 Order information received by Canada Post

PRO
Synthiam
#14  

Well that isn't very helpful information from Canada Post, is it? Hmm!! Can you send me a message (from the FAQ page) with your shipment tracking number and I'll get hold of Canada Post and see what's up?

Netherlands
#15  

Oh the mail also said:

Carrier: Canada Post Service Type: International Surface Small Packets (4 - 6 weeks)

stress

PRO
Synthiam
#16  

That's strange! They are all shipped airmail. Somehow that is a mistake. I hope the entire shipment wasn't surface. Grrrrrrr:(