Robot Building Questions

Controlling Two Brookstone Rovers

Hi guys, I wanted to know if I can control two Brookstone rovers with one computer and two wireless cards. Its for a school project. Each card would connect to one of the rovers. I tried doing this with the ARC software and was unable to do so since it wouldn't let me add more than one control for the rover even though I was connected to two. I was...

Making A Design For Ir Control Using Ezb And Interface To Ezb

I am making a small design to use with EZB to control robosapiens and other IR control robots without direct connection IF it works on my robosapien models it work on any other robots,so you dont need to hack the robots if you dont want too,plus able to control other robots with IR too IT will take a few parts ,first building the carrier frequency...

Is Telnet 2Way ¿

Hello I know you can send commands to EZ-B using Telnet just wondering it EZ-B can send into back to the Telnet

R2d2 Builders!

R2D2 builders! I am looking for a R2D2 toy under 2 feet tall. What toy have you used? Please reply!

High Power Servo

Hi All. I understand that this servo does best with 6V. https://www.hobbyking.com/hobbyking/store/__8496__Turnigy_S8166M_Servo_154g_33kg_21sec.html Can I simply connect the + and - wires from another power source to the servo, and connect the white wire to the EZ-b, or is something more complicated (like a voltage booster) needed? thanks in...

Live Stream And Android Using Ez-B

Hello everyone I'm currently in the development of a development of a robot, that uses EZ-B microcontroler and camera, I would like to implement an Android Application that would display the live stream from the bluetooth camera into the android device, and as well be able to manipulate the robot through Application, I would like to know if this is...

Maximum Voltage/Voltages For The Ez-B?

Hello. Currently in my robotics project, I am using a lot of electronic components such as leds that are eating up my batteries instantly. I am thinking about using a power adapter to keep the current running to all of my electronics. Is there a maximum voltage other than 9 volts to maintain a strong, on-going current to fuel my project, and if so,...

Attaching An Led To A Digital Port?

What is the best way to attach an LED as an indicator on a digital port? I tried by connecting an LED with a 330 ohm resistor to the GND and signal pins, and this works, but I just wondered if this should best be done with external power (I plan to add several of these) or off of the EZ-Robot board? I will be running off of a battery once I get...