My new update Arm robot 11/14/2019

EzAng

USA
Skip to comments   Jump To End

My new update to the Robot arm, added a 5th servo to the gripper - using auto-position - Ez builder software and Ezb4 this time,  5 servos total  MG996R SERVOS - also used a shorter brace to hold the gripper

By — Last update

Other robots from Synthiam community

Doombot's Dirgebot V1

Doombot's Dirgebot V1

Hello all Its been a while since I posted, been busy catching up on back orders for IKON so that took up most of my...
Drephreak's New Robot

Drephreak's New Robot

Hi Fellas. I havent been here for a while but have been keeping up from time to time anyways I wanted to introduce my...
Jphillipsnj's 6 Servo Arm Using Vb.Net, Visual Studio 2010 Code And Video

Jphillipsnj's 6 Servo Arm Using Vb.Net, Visual Studio 2010...

Hi, I am writing a lot of code for EZ and I would like to share some of VB code. Here is the code for the video below....

ARC Pro

Upgrade to ARC Pro

Unleash your creativity with the power of easy robot programming using Synthiam ARC Pro

PRO
USA
#1   — Edited

Thank Nomad 6r  -  I received your email

Should I do a different video?

Login to post a comment