Asked
— Edited
i see the pose stand from sit is not in auto position. so it cant be adjust?
anyone thank you
Set Digital
— Toggle a digital I/O port between TTL low (0V) and high (3.3V/5V) in ARC; select board and port, simple on/off control-signal only.
Try it →
All poses are in the auto position. Look at the ACTION "Stand From Sit" to see what FRAMES it uses. Find out more on how to use the Auto Position by looking at the manual page here: https://synthiam.com/Tutorials/Help.aspx?id=180
dj
hmm i dont see it ?what am i missing.
All poses are in the auto position. Look at the ACTION "Stand From Sit" to see what FRAMES it uses. Find out more on how to use the Auto Position by looking at the manual page here: https://synthiam.com/Tutorials/Help.aspx?id=180
ah action=stand from sit.ive seen more off this.
thank you dj
ah found it .jeeze