i see the pose stand from sit is not in auto position. so it cant be adjust?
anyone thank you
Auto Release
— Auto-release servos after inactivity: set EZB board/ports, choose 1-60s delay, add/remove ports, pause and view status.
Try it →
i see the pose stand from sit is not in auto position. so it cant be adjust?
anyone thank you
All poses are in the auto position. Look at the ACTION "Stand From Sit" to see what FRAMES it uses. Find out more on how to use the Auto Position by looking at the manual page here: https://synthiam.com/Tutorials/Help.aspx?id=180
dj
hmm i dont see it ?what am i missing.
All poses are in the auto position. Look at the ACTION "Stand From Sit" to see what FRAMES it uses. Find out more on how to use the Auto Position by looking at the manual page here: https://synthiam.com/Tutorials/Help.aspx?id=180
ah action=stand from sit.ive seen more off this.
thank you dj
ah found it .jeeze