HT16K33 Animator (8X8) icon HT16K33 Animator (8X8) — Control for Adafruit 8x8 LED Matrix (HT16K33) via EZ-B v4 I2C; creates animations, supports module initialization and EZ-Script control. Try it →
Asked — Edited
Resolved Resolved by Dave Schulpius!
12 Volt Power Supply Recommendation Needed

12 Volt Power Supply Recommendation Needed

Evening All

I'm looking for a 12 volt power supply recommendation for a build. I'm running 4 12 volt motors (nothing heavy duty) with H bridges, a sound and neon system, and a few smaller setups (lower voltage). I'll be tying in an EZ board (last generation board until I upgrade my laptop) and using voltage regulators along with plenty of fuses. I'm fine with internal or external (my build is stationary for now). I'm thinking 6 amps should be sufficient. Power bricks like those used for laptops have been suggested but I want to look at all my options.

Any advice is always welcome.

Thanks,

Daniel


ARC Pro

Upgrade to ARC Pro

Elevate your robot's capabilities to the next level with Synthiam ARC Pro, unlocking a world of possibilities in robot programming.

#1  

A lot will depend on how long you want the robot to function. Lithium packs will offer the amperage capacity with less weight and heat but at a higher cost than SLA (Sealed Lead Acid) packs that cost less and weigh more.

#3  

Hi Danial,

I use these in my B9. I have one in the leg section and a couple more in the torso. Probably overkill but when it comes to power I think you cant have enough. They input 120 VAC and put out 12 VDC with max 12.5amp.

150W 12V Regulated Power Supply

User-inserted image

#4  

Thanks everyone. I think I'm good to go.

Daniel