Ok this is the second project where EZB will be used to control lighting , current flow , temp , salinity ect. This thread will show just about every step ot the build , electronics , wiring and eventually the scripts to make it work. 
- Josh Starnes
By jstarne1
— Last update
Discover more robots
Ezang's New Mr. Metal Robot 2020
Build Mr. Metal robot with Synthiam ARC using EZb4 controller, EZrobot 1300 camera, four EZ 360 HDD servos, Servo City...
Cliffordkoperski's HAL THE ROBOT THAT WALKS AND TALKS
5.5ft humanoid walks, talks-56 servos on 3 EZB v4 boards via WiFi, two batteries, onboard PC; Synthiam ARC scripting...
Faengelm's Rider The Ball Kicker Servo Port Numbers
Set Synthiam ARC project port numbers to run Auto Position Actions like Kick, Thanks, and Frank for proper action...
Alright I'm epoxying down the buck stepdown converter . with a load I could maintain 9.5 volts from a lead acid battery. I will test load voltage again in a few minutes from the 12v regulated power supply I made from a PC power supply for it.HEY that looks like my stepdown converter ,LOL BECARE YOU DONT have your burner on doing that,or forget its on
My new GLASS RANGE was on and i couldnt tell ,since not red and it almost melted my lid
OK I'm waiting for the paint to dry well while I go pick up my car then when I get back I will crimp the ends on the power wires and test the voltage to the LEDs while on the big power supply. As long as its below 11 volts I will reassemble the case and be done
The light looks great! So now I fed some of my anemone specimens. It appears the two colors that the anemone takes to the best are green , yellow and red. Blue is not nearly effective in direct comparison. I did find that flouresent colors/ pigments show through the anemones skin. Next I will look into adding a glowing pigment that charges from light absorbed and glows for a few hours in darkness.
Man, that looks great! I love the colors. I gotta get my aquarium back running again.
Update: I ended up removing the step down converter and now I'm connected directly to 12v from the computer power supply. I tested the voltage with 7 amps of load and my meter read 11.4 volts and these leds are rated 10.1 to 11 volts so I am not worried. The heatsink and fans are working well.
@Dch thanks! If I can raise lots of anemone in different colors I will start selling them. I love these guys.