use webcam with ez-b v4

Question

I'm intending to use this conversion circuit to integratethe camera with ez_b, hopefully everyone can give me an advice before I buy it. USB UART switch CP2102 uses CP2102 chip fromSILICON LABS which is used to transfer USB to UART TTL and vice versa Foot description is as follows: TXD: UART data transmission pins, used to connect to Rx pinsof other modules, not directly connected to the level of RS232RXD: pins to receive UART data, use connection to Tx pins ofother modules, do not connect directly to the level of RS232GND: mass or ground.5V: positive voltage source (maximum 500mA).DTR: Reset pin to load for microcontroller3.3V: 3.3V positive voltage source?

ptp · Answer

Quote:conversion circuit to integrate the camera with ez_b Can you explain ? Possible scenarios: 1)  EZB controller's camera port only supports the EZ-Robot camera https://www.ez-robot.com/Shop/AccessoriesDetails.aspx?prevCat=104&productNumber=1351 2)  EZ-Robot camera https://www.ez-robot.com/Shop/AccessoriesDetails.aspx?prevCat=104&productNumber=1351 can be connected to the PC using a USB-UART device and it's only supported by the EZ-Builder software.