All Community Content

Servo Position

Good Morning, I think I have noticed or at least I seem to think I have, but when I ask a servo to move to a predefined location, it does it at least 50 percent of the time. I have to disconnect and remove power on my V4 board to get my project to do what I want it to do. Thoughts?

Receiving And Using Uart Data In Script

I've been trying to receive data through the Uart port in EZB V4 and use it in a script. I've successfully been sending special commands to move my motor to exact points through a Kangaroo/Sabertooth combination and that's working great. I've even been able to read how many Bytes are in the buffer useing the below Script. This Script successfully...

Is There A Global Command For Repeating A Script That Was Just Executed?

I am looking to see if ARC has a global command for repeating the last script executed. Example: #Nudge Right Script # Turn turn the robot right just a little at a speed of 150, then return to max motor settings at 255 right(150, 200) right(255, 1) stop() #Nudge left Script # Turn turn the robot left just a little at a speed of 150, then return...

Rovospy

How easy would it be to hack this with the EZ-B V4? Including the infrared camera and LEDs https://youtube.com/watch?v=BLzfH_jmzas

Nice Introduction To Home Networking

As the first EZ-B4's shipped, there have been a lot of conversations about connecting to home networks and a good number of just general network questions. I came across a nice article today that gives a basic introduction to home networking that I think is a good start. It doesn't cover three of the critical items that will come up with EZ-B v4...