All Community Content

Autonomoues Wall-E

Hello everybody! My name is Alessio, I'm italian and a new member! I just recently purchased an Ultimate Wall-E robot of Thinkway, and my goal is to turn it into an autonomous robot, just like djsures did with his Wall-E. I wondered, as my model (Ultimate) is very large (about 16" tall) how can I make an internal system, so as to make it...

Listen To Eventhandler In C++ Without Gui

I'm attempting write a small c++ cli program with which I can connect to and control each servo. However, I am running in to the problem of making the connection without using a gui. Does anyone have an idea of how I can listen to the eventhandler without using the gui? What I have so far is this: #include #include #include "stdafx.h"...

I Want To Make Jd Longer Out Of 5 Servos Instead Of 2

Hello, I want to make JD's legs and arms with 3 or 4 servo each. Has any one try making JD with Longer arms and legs, I'm wondering also how JD will move with more servos ? Please HELP Thank you.

Teddy Ruxpin Wiring

Hi Folks I am a new member, a retired clergyman going back to my earlier vocation in electronics. I have had a lot of fun with Arduino and was intrigued by the current Make magazine article on Teddy Ruxpin and Chip. Unfortunately Chip will not ship until June. So I thought I would look at doing it with Photon. I found a pristine Ruxpin of the non...

I2c In C# Not Reading Values

I have mpu-6050 6dof imu. I want to read the value of who_am_i register with register number 0x75. The register returns address 0x68. But I am getting 255. The device address is 0x68 as well. Code is as follows: byte[] ret = ezB_Connect1.EZB.I2C.Read(I2C.ReadArgsEnum.Auto,0x75,1); here is the register description for the device:RM-MPU-6000A.pdf I...