Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Other robots from Synthiam community
Andy's Happy Holidays
A Holiday Wish from Antonn.
Dunning-Kruger's My Inmoov Bartender
Well after seeing Bob Houstons inMoov (hard act to follow by the way) on here a while back I knew I had to make one too....
R2D2's Robot Building
Hello, greetings to all robot builders, I am eager to receive the board ez-b, to give life to my butler robot, robot...
Noma d where are you?
come back and try it mickey
@EzAng.... Time zones EzAng, there are 24 of them... It is 2:13am in Germany at the time of this post.... Maybe they went to bed?
Hey Nomad, maybe you should modifiy the stand for ZOE a little bit befor printing, because the body will be a little lower that the level of your base! It will also work your way, but I will be building a new body soon which also holds the speaker and Neo Pixel, so maybe it would be nice to have some room available...kind of like this!
Because the body will surpass your floor level...its kinda like this!!
hey mickey
good idea i can make an extra block as in your picture.
what about this idea?lots off spare room.little smaller then the lower block.
Sure, looks good...I am making a test print to make sure everything works out fine, then I will send you the new part so you can check if it works with your design!! It looks like this...