Omnibot 2000 , Rad 2.0 Vacuum Bot

Skip to comments Jump to end

This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.

By jstarne1 Jan 2012 — Last update Mar 2013

jstarne1

USA

Jump to end

Discover more robots

Upgrade to ARC Pro

Get access to the latest features and updates before they're released. You'll have everything that's needed to unleash your robot's potential!

Compare Pro Features View Subscription Plans

jstarne1

USA

#961 Jul 2012

The Bondo is just a filler , I planned on backing this with epoxy , then a couple layers of fiberglass , the filler is here instead of fiberglass because its ten times easier to sand for paint. The glob you see on the outside of the shoulder is to fill the original screw hole that attatched the shoulder , I will have a cool S logo here.

Troy

USA

#962 Jul 2012

Good forethought on the neck. Great looking progress as always!

bret.tallent

USA

#963 Jul 2012

Hey Josh, I have some 3" flexible duct that is very strong yet very soft and bendy that could work for your neck or shoulder joints. Interested?

Troy

USA

#964 Jul 2012

Hey Bret. I may be interested in that blue duct if the black I ordered doesn't work out. What is the inner and outer diameter?

bret.tallent

USA

#965 Jul 2012

Inner is 2 1/2 and outer is 3". It is a high strength vinyl with wire coil. Kind of like dryer vent duct but a lot stronger. It was just a little too big for my B9 build.