I want to build a 40cm boxing/fighting robot from scratch with carbon fiber structural frame and PLA 3D-printed exterior. The robot will use EZ-B v4 as controller unit with modified power system to accommodate power requirement of 17 to 10 high voltage high torque servos.
Other robots from Synthiam community
Justinratliff's Jd Backpack
I did a mock up of the JD backpack based on suggestions from @WBS00001 and @ptp from my C3PO JD head post. It has a male...
Bmcnamee1's Extending Jd
We have designed and 3D printed pieces with both a male and female parts, that connects in between the servos to make JD...
Rb550f's Ez Robot Rover V2
Here are design updates on my EZ robot rover. The drive train is made from a Sharper Image EVAC. Uses EZB V3...Used a...
